Nya frågor CCNP1Ars110
Three Cisco IOS commands:
* neighbor 10.0.0.1
*network 10.0.0.2
*ping 10.0.0.3
What does 10.0.0.1 mean in the above example?
the peering IGP/EGP router
Three Cisco IOS commands:
*neighbor 10.0.0.1
*network 10.0.0.2
*ping 10.0.0.3
the peering IGP/EGP router
What does 10.0.0.3 mean in the above example?
the traffic destination-address
What is true regarding GLBP?
There can be 4 Active Virtual Gateways per group
What are the BGP Neighbor Adjacency States ?
Idle,connect,active,
opensent,openconfirm,
established
Match EIRGP terminologies : Successor
Successor is the neighbor chosen to reach a destination, it's the next-hop of the route.
Match EIRGP terminologies: Feasibility Condition
To be considered a backup route, the reported distance received from a certain route must be less than the feasible distance calculated locally
Match EIRGP terminologies: Feasible Successor (FS)
The Feasible Successor is the next-hop of the Backup route, in the event that the successor fails
Match EIRGP terminologies: Reported Distance (RD)
The metric advertised by our neighbor toward a certain destination
Match EIRGP terminologies: Successor Route
The route with the lowest metric to reach a destination
Match EIRGP terminologies: Feasible Distance (FD)
The total metric to reach the destination
What must be understood about the VRRP master when troubleshooting the Virtual Router Redundancy Protocol (VRRP)?
The master is not aware of the backup router.
What is true about IGMP Snooping regarding Multicast? Välj ett alternativ:
The switch listens to IGMP joins sent by clients and adds the group's multicast mac address to the mac address-table for the port it was received on
When using the command route-map xxXxx permit 10, the sequence-number starts at 10. But what happens when you add a new route-map statement without specifying the sequencenumber?
The sequence-number will increment by 10
Which Multicast address will OSPF use in a none DR/BDR network?
224.0.0.5
Which three transitioning techniques are there for IPv4 to IPv6? (Choose 3) Välj ett eller flera alternativ:
Tunneling techniques
Translation techniques
Dual-stack techniques
What could be a cause of RIB-failure in BGP?
That a route with a better administrative distance already exists in the RIB table
How does the routing table reflect the link-state information of an inter-area route?
It is marked with O IA
In which order, starting from most preferred to least preferred method will break the tie of what will become the router ID in OSPF.
Router ID, Highest IP address on Loopback, Highest IP address
What is a difference between autonomous APs that operate in a home environment and controller-based APs that operate in a corporate environment?
Controller-based APs can be automatically configured and managed by a WLAN controller
What are two benefits of deploying a centralized wireless LAN topology? (Choose two)
maximizing the number of APs that can join a single WLC
convenience of enforcing security policies for all wireless users
What is the role of the fabric edge node in the SD-Access fabric overlay?
connecting wired endpoints to the SDA fabric
Which configuration management tool uses an agentless approach?
Ansible
What is the function provided by CAPWAP protocol in a corporate wireless network?
CAPWAP provides the encapsulation and forwarding of wireless user traffic between an access point and a wireless LAN controller
What does the command "channel-group 1 mode active" do when configured on DLS1 and DLS2?
Enables LACP unconditionally
Which methods can be used when implementing path control? (choose 3)
Static routes
cost
PBL
What do 2 & 3 stand for in the commands during the IP SLA configuration?
ip route 0.0.0.0 0.0.0.0 10.1.1.1 2 track 1
ip route 0.0.0.0 0.0.0.0 172.16.1.1 3 track 1
AD value
A network administrator configures 10 VLANs ranging from VLANs 2021 to 2030 in an enterprise
network. Which version of VTP supports these VLANs?
Version 3
Which of the following protocols supports VXLAN?
BGP
What does 10.0.0.3 mean in the above example?
Välj ett alternativ:
the traffic destination-address
Does not participate in frame forward in STP at all
disabled
Does not participate in frame forward
blocking
Sends and receives BPDUs to determine root, but does not update the MAC address
listening
Sends frames
forwarding
Populates the MAC address table but will not forward user data
learning
The BGP protocol can be in different states. What does the idle (admin state) indicate? Välj ett alternativ:
The neighbor ip address shutdown command has been issued