CCNP1 ARS110
Three Cisco IOS commands:
neighbor 10.0.0.1
network 10.0.0.2
ping 10.0.0.3
What does 10.0.0.1 mean in the above example?
the peering IGP/EGP router
Three Cisco IOS commands:
• neighbor 10.0.0.1
• network 10.0.0.2
• ping 10.0.0.3
the traffic destination-address
Three Cisco IOS commands:
• neighbor 10.0.0.1
• network 10.0.0.2
• ping 10.0.0.3
What does 10.0.0.3 mean in the above example?
Välj ett alternativ:
the traffic destination-address
What is true regarding GLBP?
Välj ett alternativ:
GLBP can load balance a single vlan across multiple servers
What are the BGP Neighbor Adjacency States ?
Välj ett alternativ:
Idle,connect,active,opensent,openconfirm,established
Matcha ihop värdena:
The metric advertised by our neighbor toward a certain destination
Reported Distance (RD)
Matcha ihop värdena:
The total metric to reach the des tination
Feasible Distance (FD)
Matcha ihop värdena:
The Feasible Successor is the next- hop of the Backup route, in the event that the successor fails
Feasible successor (FS)
Matcha ihop värdena:
Successor is the neighbor chosen to reach a destination, it's the next-hop of the route
Successor Route
Matcha ihop värdena:
To be considerd a backaup route, the reported distance recived form a surten route must be less then the feasible distance caluculated localy
Feasibility Condition
Matcha ihop värdena:
The route with the lowest metric to reach a destination
Successor (S)
What must be understood about the VRRP master when troubleshooting the Virtual Router
Redundancy Protocol (VRRP)?
Välj ett alternativ:
The preempt option must be enabled on the master.
What is true about IGMP Snooping regarding Multicast?
Välj ett alternativ:
The switch listens to IGMP joins sent by clients and adds the group's multicast mac address to the mac address-table for the port it was received on
When using the command route-map xxXxx permit 10, the sequence-number starts at 10. But What happens when you add a new route-map statement without specifying the sequence- number?
Välj ett alternativ:
The sequence-number will increment by 10
Which Multicast address will OSPF use in a none DR/BDR network?
Välj ett alternativ:
224.0.0.5
Which three transitioning techniques are there for IPv4 to IPv6? (Choose 3)
Välj ett eller flera alternativ:
Dual-stack techniques
Translation techniques
Tunneling techniques
What could be a cause of RIB-failure in BGP?
Välj ett alternativ:
That a route with a better administrative distance already exists in the RIB table
How does the routing table reflect the link-state information of an inter-area route?
Välj ett alternativ:
It is marked with O IA
In which order, starting from most preferred to least preferred method will break the tie of what
will become the router ID in OSPF.
Välj ett alternativ:
Router ID, Highest IP address on Loopback, Highest IP address
What is a difference between autonomous APs that operate in a home environment and controller-based APs that operate in a corporate environment?
Välj ett alternativ:
Controller-based APs can be automatically configured and managed by a WLAN controller
What are two benefits of deploying a centralized wireless LAN topology? (Choose two)
Välj ett eller flera alternativ:
maximizing the number of APs that can join a single WLC
convenience of enforcing security policies for all wireless users
What is the role of the fabric edge node in the SD-Access fabric overlay?
Välj ett alternativ:
connecting wired endpoints to the SDA fabric
Which configuration management tool uses an agentless approach?
Välj ett alternativ:
Ansible
What is the function provided by CAPWAP protocol in a corporate wireless network?
Välj ett alternativ:
CAPWAP provides the encapsulation and forwarding of wireless user traffic between an access point and a wireless LAN controller
What does the command "channel-group 1 mode active" do when configured on DLS1 and
DLS2?
Välj ett alternativ:
Enables LACP only if an LACP device is detected